Server Technology switched pro2 User Manual page 136

Command
set https
set ipv4, set ipv6
set ldap
set ldapgroup
set line
set loadshed
set location
set net
set ocp
set outlet
set phase
set port
set radius
set sensor
set snmp
set sntp
set spm
set ssh
set syslog
set tacacs
set tacpriv
set telnet
set trend
set unit
set ups
Using the Command Line Interface (CLI)
Description
Sets HTTPS configuration values.
Sets IPv4 and IPv6 configuration values.
Sets LDAP configuration values.
Sets configuration values for LDAP group access rights.
Sets line configuration values.
Sets Smart Load Shedding configuration values.
Note: Only available if the Smart Load Shedding feature is activated.
Sets the system location string.
Sets network mode configuration values.
Sets over-current protector (OCP) configuration values.
Sets outlet configuration values.
Sets phase configuration values.
Sets serial port configuration values.
Sets Radius server configuration values.
Sets sensor configuration values.
Sets SNMP configuration values.
Sets SNTP configuration values.
Sets Sentry Power Manager (SPM) access configuration values.
Sets SSH configuration values.
Sets Syslog configuration values.
Sets TACACS+ server configuration values.
Sets TACACS+ configuration values for privilege level access rights.
Sets Telnet configuration values.
Sets power trending configurations.
Sets PRO2 configuration values.
Sets UPS device configuration values.
Switched PRO2 – User Guide
•
136