Server Technology switched pro2 User Manual page 157

set email
Sets email configuration values.
Command Syntax
set email auth [disabled | enabled]
set email config [disabled | enabled]
set email [disabled | enabled]
set email event [disabled | enabled]
set email fromaddr <email addr>
set email power [disabled | enabled] See
set email smtp authtype [any | crammd5 | digestmd5 | login | plain | none]
set email smtp host <hostname>
set email smtp password <password>
set email smtp port <port>
set email smtp usefromaddr
set email smtp username <user name>
set email smtp useusername
set email test
set email toaddr1 <email addr>
set email toaddr2 <email addr>
set email trendfiles [disabled | enabled]
set email usesubjloc
set email usesubjdef
Note: The set email power command is for Switched products only.
Parameters
The set email command uses the following parameters:
Using the Command Line Interface (CLI)
auth Sets if authentication log messages are relayed by email
config Sets if configuration log messages are relayed by email.
event Sets if event log messages are relayed by email.
fromaddr Sets the email address the messages are relayed from.
0-48 characters.
power Sets if power log messages are relayed by email.
authtype Sets the type of authentication to use when logging into the relay SMTP
server.
host Sets the host where the relay SMTP server is located.
0-63 characters.
password Sets the password for logging into the relay SMTP server
0-32 characters.
port Sets the port number for the relay SMTP server, 1-65535 (default 25).
toaddr1 Sets the first address to send email messages to. 0-48 characters.
toaddr2 Sets the second address to send email messages to. 0-48 characters.
trendfiles Sets the preference to have new trending report files sent out daily to
both "toaddrr" addresses at midnight.
Switched PRO2 – User Guide
Note below.
•
157