Server Technology switched pro2 User Manual page 137

Command
set user
set wlan
Show Commands
show access
show bluetooth
show branches
show cords
show email
show energywise
show features
show ftp
show ldap
show lines
show loadshed
show log
show network
show ocps
show outlets
show phases
show ports
show radius
show sensors
show shutdown
show snmp
show sntp
Using the Command Line Interface (CLI)
Description
Sets configuration values for local user access rights.
Sets the wireless network configuration (for the WLAN solution on specific Wi-Fi capable
PRO2 units).
The Show command group displays the current configuration values in the system.
Shows user access configuration values.
Shows Bluetooth configuration values.
Shows branch configuration values.
Shows cord configuration values.
Shows email configuration values.
Shows Cisco EnergyWise configuration values.
Shows the enabled system features.
Shows FTP configuration values.
Shows LDAP configuration values.
Shows line configuration values.
Shows Smart Load Shedding configuration values.
Note: Only available if the Smart Load Shedding feature is activated.
Shows the system event log.
Shows network configuration values.
Shows over-current protector (OCP) configuration values.
Shows outlet configuration values.
Shows phase configuration values.
Shows port configuration values.
Shows Radius server configuration values.
Shows sensor configuration values.
Shows outlet shutdown configuration values.
Shows SNMP configuration values.
Shows SNTP configuration values.
Switched PRO2 – User Guide
•
137