Table of Contents
Advertisement
1.
Rear bracket, short or long
Attaching the rear brackets to the front rack posts
Complete the following steps to attach the rear brackets to the front rack posts.
1.
Attach the right rear bracket to the right front rack post using two 10-32 x 5/8-in. screws and two retainer nuts, as shown in
Figure
14. Use the upper and lower holes in the bracket.
2.
Attach the left rear bracket to the left front rack post using two 10-32 x 5/8-in. screws and two retainer nuts. Use the upper and
lower holes in the bracket.
3.
Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
FIGURE 14 Attaching the rear brackets to the front rack posts
1.
Screws, 10-32 x 5/8-in., panhead Phillips
Installing the Universal Two-Post Rack Kit (XBR-
R000294)
Use the following instructions to install a Brocade 1U or 2U device in a two-post telecommunications (Telco) rack using the Universal
Two-Post Rack Kit (XBR-R000294).
There are two ways you can mount the device in a two-post rack:
•
With the port side flush with the front posts
•
With the posts mounted to the mid-section of the device
Brocade G620 Hardware Installation Guide
53-1003990-06
Installing the Universal Two-Post Rack Kit (XBR-R000294)
2.
Screws, 6-32 x 1/4-in., panhead Phillips
2.
Retainer nuts, 10-32
39
Advertisement
Table of Contents
