Brocade Communications Systems G620 Hardware Installation Manual page 42

Installing the Universal Two-Post Rack Kit (XBR-R000294)
4. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
FIGURE 16 Attaching the front brackets
1. The Brocade device
2. Front brackets, right and left
Attaching the front brackets to the rack
Complete the following steps to install the device in the rack.
1. Position the device in the rack, as shown in
secured to the rack.
2. Attach the right front bracket to the right rack upright using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use the
upper and lower holes in the bracket.
3. Attach the left front bracket to the left rack upright using two 10-32 x 5/8-in. panhead screws and two retainer nuts.
Use the upper and lower holes in the bracket.
42
(Figure 17), providing temporary support under the device until the rack kit is fully
3. Screws, 8-32 x 5/16-in., flathead Phillips
Brocade G620 Hardware Installation Guide
53-1003990-06