Brocade Communications Systems G620 Hardware Installation Manual page 33

5. Adjust the brackets to the rack depth and tighten all the 6-32 x 1/4-in. screws to a torque of 9 in-lb (10 cm-kg).
FIGURE 7 Attaching the rear brackets to the extensions
1. Rear brackets
Attaching the rear brackets to the rack posts
Complete the following steps to attach the rear brackets to the rack posts.
1. Attach the right rear bracket to the right rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts, as
shown in Figure 8. Use the upper and lower holes in the bracket.
2. Attach the left rear bracket to the left rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use the
upper and lower holes in the bracket.
Brocade G620 Hardware Installation Guide
53-1003990-06
Installing the Universal Four-Post Rack Kit (XBR-R000296)
2. Screws, 6-32 x 1/4-in., panhead Phillips
33