Brocade Communications Systems G620 Hardware Installation Manual page 31

5. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
FIGURE 5 Attaching the bracket extensions to the device
1. Bracket extension
Installing the device in the rack
Complete the following steps to install the device in the rack.
1. Position the device in the rack, as shown in
the rack.
2. Attach the right front bracket to the right front rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use
the upper and lower holes in the bracket.
3. Attach the left front bracket to the left front rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use the
upper and lower holes in the bracket.
Brocade G620 Hardware Installation Guide
53-1003990-06
Figure 6, providing temporary support under the device until the rail kit is secured to
Installing the Universal Four-Post Rack Kit (XBR-R000296)
2. Screws, 8-32 x 5/16-in., flathead Phillips
31