Brocade Communications Systems G620 Hardware Installation Manual page 30

Installing the Universal Four-Post Rack Kit (XBR-R000296)
4. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
FIGURE 4 Attaching the front brackets
1. The Brocade device
2. Front brackets
Attaching the bracket extensions to the device
Complete the following steps to attach the extension brackets to the device. There are medium and long extension brackets that you can
use for this step.
1. Select the proper length bracket extension for your rack depth.
2. Position the right bracket extension along the side of the device as shown in
3. Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the bracket extension and then into the holes
on the side of the device. Use the upper and lower screw holes, leaving the center holes empty.
4. Repeat step 2 and step 3 to attach the left bracket extension to the left side of the device.
30
3. Screws, 8-32 x 5/16-in., flathead Phillips
Figure 5.
Brocade G620 Hardware Installation Guide
53-1003990-06