Brocade Communications Systems G620 Hardware Installation Manual page 37

4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
FIGURE 11 Positioning the device in the rack
1. Screws, 10-32 x 5/8-in., panhead Phillips
Attaching the rear brackets to the extensions at the front of the device
Complete the following steps to attach the rear brackets to the extensions. There are short and long front brackets that you can use for
this step.
1. Select the proper length rear bracket for your rack depth.
2. Slide the right rear bracket onto the right extension.
The short rear brackets are shown in
Refer to Figure 13
3. Attach the brackets using four 6-32 x 1/4-in. panhead screws.
4. Repeat step 2 and step 3 to attach the left rear bracket to the left extension.
Brocade G620 Hardware Installation Guide
53-1003990-06
Figure 12. Use the first and third vertical pairs of holes for the screws.
for the positioning of the short or long brackets and screws.
Installing the Universal Four-Post Rack Kit (XBR-R000296)
2. Retainer nuts, 10-32
37