Installing the Universal Four-Post Rack Kit (XBR-R000296)
3.
Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
FIGURE 8 Attaching the rear brackets to the rack posts
1.
Screws, 10-32 x 5/8-in., panhead Phillips
Flush-rear (recessed) mounting
The flush-rear (recessed) mounting is similar to the flush-front mounting except that the brackets are reversed on the device.
CAUTION
The device must be turned off and disconnected from the fabric during this
procedure.
NOTE
The illustrations in the rack installation procedures show a 1U device, but the instructions are the same for a 2U device. The
illustrations in the rack installation procedures are for reference only and may not show the actual device.
Complete the following tasks to install the device in a four-post rack:
1.
Attaching the front brackets to the rear of the device
2.
Attaching the extensions to the front of the device
3.
Installing the device in the rack
4.
Attaching the rear brackets to the extensions at the front of the device
5.
Attaching the rear brackets to the front rack posts
34
on page 35
on page 35
on page 36
on page 39
2.
Retainer nuts, 10-32
on page 37
Brocade G620 Hardware Installation Guide
53-1003990-06