Installing the Universal Four-Post Rack Kit (XBR-R000296)
4.
Repeat step 2 and step 3 to attach the left front bracket extension to the left side of the device.
5.
Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
FIGURE 10 Attaching the bracket extensions to the device
1.
Extension brackets
Installing the device in the rack
Complete the following steps to install the device in the rack.
1.
Position the device in the rack, as shown in
to the rack.
2.
Attach the right front bracket to the right rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use
the upper and lower holes in the bracket.
3.
Attach the left front bracket to the left rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use the
upper and lower holes in the bracket.
36
Figure
11, providing temporary support under the device until the rail kit is secured
2.
Screws, 8-32 x 5/16-in., flathead Phillips
Brocade G620 Hardware Installation Guide
53-1003990-06