Network Settings (Common Settings) - peplink Balance One User Manual

Network
A
Isolation
When Layer 2 bridging is enabled, this field specifies the port to be bridged to the remote
Spanning Tree
site. If you choose WAN, the selected WAN will be dedicated to bridging with the remote
A
Protocol
site and will be disabled for WAN purposes. The LAN port will remain unchanged.
Override IP
Select "Do not override" if the LAN IP address and local DHCP server should remain
Address when
unchanged after the Layer 2 PepVPN is up.
bridge is
If you choose to override IP address when the VPN is connected, the device will not act as
a router, and most Layer 3 routing functions will cease to work.
A
connected
A
- Advanced feature, please click the
Settings menu to activate.

12.2.3 Network Settings (Common Settings)

For VLAN-enabled configurations, DHCP Server settings are accessible by clicking individual
VLAN
When this setting is enabled, the Peplink Balance's DHCP server automatically assigns an
IP address to each computer that is connected via LAN and configured to obtain an IP
DHCP Server
address via DHCP. The Peplink Balance's DHCP server can prevent IP address collisions
on the LAN.
http://www.peplink.com
button on the top right-hand corner of the Network
DHCP Server Settings
66 Copyright @ 2017 Peplink