Mediafast - peplink Balance One User Manual

For more information, please visit peplink.com
Hide thumbs Also See for Balance One:
Table of Contents

Advertisement

This refers to the LAN host's private IP address. The system maps this address to a
Address
number of public IP addresses (specified below) in order to facilitate inbound and
outbound traffic. This option is only available when IP Address is selected.
The IP range is a contiguous group of private IP addresses used by the LAN host. The
Range
system maps these addresses to a number of public IP addresses (specified below) to
facilitate outbound traffic. This option is only available when IP Range is selected.
The IP network refers to all private IP addresses and ranges managed by the LAN host.
Network
The system maps these addresses to a number of public IP addresses (specified below)
to facilitate outbound traffic. This option is only available when IP Network is selected.
This setting specifies the WAN connections and corresponding WAN-specific Internet IP
addresses on which the system should bind. Any access to the specified WAN
connection(s) and IP address(es) will be forwarded to the LAN host. This option is only
available when IP Address is selected in the LAN Client(s) field.
Inbound
Mappings
Note 1: Inbound mapping is not needed for WAN connections in drop-in mode or IP
forwarding mode.
Note 2: Each WAN IP address can be associated to one NAT mapping only.
This setting specifies the WAN IP addresses should be used when an IP connection is
made from a LAN host to the Internet.
Each LAN host in an IP range or IP network will be evenly mapped to one of each
selected WAN's IP addresses (for better IP address utilization) in a persistent manner (for
Outbound
better application compatibility).
Mappings
Note 1: If you do not want to use a specific WAN for outgoing accesses, you should still
choose default here, then customize the outbound access rule in the Outbound Policy
section.
Note 2: WAN connections in drop-in mode or IP forwarding mode are not shown here.
Click Save to save the settings when configuration has been completed.
Inbound firewall rules override inbound mapping settings.

12.7 MediaFast

MediaFast settings can be configured by navigating to Network > MediaFast.
http://www.peplink.com
Important Note
106
Copyright @ 2017 Peplink

Advertisement

Table of Contents
loading

Table of Contents