Bosch DSA E-Series (E2700) Installation Manual page 64

64 en | Turning on the power and checking for problems in an E2700 controller-drive tray configuration
LEDs on the ESM canister
Location LED
1 Host link 1 fault
2 Host link 1 active
3 Host link 2 fault
4 Host link 2 active
5 Ethernet link active
6 Ethernet link rate
7 ESM expansion link
fault
8 ESM expansion link
active
2015.10 | V2 | DOC
1 2 3 4
9 10 1 1 12
Color
Amber At least one PHY of the four
connectors is working, but
another PHY cannot establish
the same link to the device
connected to the Host IN
port connector.
Green At least one of the four PHYs
in the In port is working, and
a link exists to the device
connected to the Host In
connector.
Amber At least one PHY of the four
connections is working, but
another PHY cannot establish
the same link to the device
connected to the Host In
port connector.
Green At least one of the four PHYs
in the IN port is working, and
a link exists to the device
connected to the Host In
connector.
Green The link is up. (The LED
blinks when there is activity.)
Green There is a 100BASE-T rate.
Amber At least one of the four PHYs
in the Out port is working,
but another PHY cannot
establish the same link to the
Expansion Out connector.
Green At least one of the four PHYs
in the Out port is working,
and a link exists to the
device connected to the
Expansion Out connector.
Installation manual
5 6 7 8
90001-01
On
No link error has occurred.
A link error has occurred.
No link error has occurred.
A link error has occurred.
The link is not active.
There is a 10BASE-T rate.
Normal status.
A link error has occurred.
DSA E-Series (E2700)
Off
Bosch Sicherheitssysteme GmbH