Bosch DSA E-Series (E2700) Installation Manual page 42

42 en | Installing the drive trays for the E2700 controller-drive tray configurations
8.
2015.10 | V2 | DOC
6 - Rear hold-down screw
7 - Cabinet mounting holes on the front EIA support rail
8 - Cabinet mounting holes on the rear EIA support rail
9 - Mounting rail lip
– Remove the rear hold-down screw. It protrudes from the inside of the rail and
prevents you from sliding the drive tray onto the rails.
– Place the mounting rail inside the cabinet, and extend the mounting rail until the
flanges on the mounting rail touch the inside of the cabinet.
– Insert one M5 screw through the front of the cabinet, and screw it into the top
captured nut in the mounting rail.
– Insert two M5 screws through the rear of the cabinet, and screw them into the
captured nuts in the rear flange in the mounting rail.
– Counting up from the bottom of the mounting rail, place the bottom of the rear
bracket in the 8th hole of the cabinet, so that the top of the rear bracket is in the
11th hole. The distance between the two holes should be 1U or 4.45 cm (1.75 in).
– Tighten the adjustment screws on the mounting rail.
– Repeat the sub steps to install the second mounting rail.
– Insert one M5 screw through the front of the mounting rail. You use this screw to
attach the drive tray to the cabinet.
Attach the shorter, adjustable size mounting rails to the cabinet.
5
6
UP
1 - Front of the mounting rail
2 - Rear of the mounting rail
3 - Rail fix bar
4 - Two M5 screws for the front EIA support rail
5 - Two clips for the front EIA support rail
6 - Rear bracket
– Make sure that the adjustment screws on the mounting rail are loose so that the
mounting rail can extend or contract as needed. The adjustment screws are on the
other side of the previous figure.
– Place the mounting rail inside the cabinet, and extend the mounting rail until the
flanges on the mounting rail touch the inside of the cabinet.
92042-01
2
3
4
Installation manual
DSA E-Series (E2700)
1
Bosch Sicherheitssysteme GmbH