Bosch DSA E-Series (E2700) Installation Manual page 39

DSA E-Series (E2700)
Notice!
Risk of equipment malfunction
To avoid possible equipment damage and ensure safe and efficient servicing of the
equipment, install 60 drive trays towards the bottom of a cabinet.
Notice!
Type and source of hazard
Consequences
Notice!
If you are mounting the DE6600 drive tray in a cabinet with square holes, use the eight
shoulder washers in the rail kit to align the screws in the holes (see step 4 through step 7).
To install the DE6600 drive-tray:
1.
2.
3.
Bosch Sicherheitssysteme GmbH
Installing the drive trays for the E2700 controller-drive tray configurations | en
Make sure that the cabinet is in the final location. Make sure that you meet the clearance
requirements shown in the following figure.
Note: Fans pull air through the drive tray from front to back across the drives.
1
1 - 91 cm (36 in.) clearance in front of the cabinet
2 - 61 cm (24 in.) clearance behind the cabinet
Lower the feet on the cabinet to keep the cabinet from moving.
Before removing the drive tray and all of the contents from the shipping carton, locate the
tray handles and attach them to the drive tray.
– Align the handle just under the thumb latch.
– Push the handle up until it clicks in place with the thumb latch.
Installation manual
39
2
92003-02
2015.10 | V2 | DOC