Table of Contents
Advertisement
36
en | Installing the drive trays for the E2700 controller-drive tray configurations
6.
7.
2015.10 | V2 | DOC
The front flange of each mounting rail has two alignment spacers. The alignment
spacers are designed to fit into the mounting holes in the cabinet. The alignment
spacers help position and hold the mounting rail.
1 - Alignment spacers
–
Insert one M5 screw through the front of the cabinet and into the top captured nut
in the mounting rail. Tighten the screw.
–
Insert two M5 screws through the rear of the cabinet and into the captured nuts in
the rear flange in the mounting rail. Tighten the screws.
–
Tighten the adjustment screws on the mounting rail.
–
Repeat the substeps to install the second mounting rail.
With the help of one other person, slide the rear of the drive tray onto the mounting rails.
The rear edge of the drive tray must fit into the clip on the mounting rail. The drive tray is
correctly aligned when these conditions are met:
–
The mounting holes on the front flanges of the drive tray align with the mounting
holes on the front of the mounting rails. Refer to item 4 in the following figure.
–
The rear edge of the drive tray sheet metal fits into the clip on the mounting rail.
–
The holes in the drive tray sheet metal for the rear hold-down screws align with the
captured nuts in the side of the mounting rails.
1
2
1 - Mounting rail
2 - Clip
3 - Partial view of the drive tray rear sheet metal
4 - Mounting holes
Secure the front of the drive tray to the cabinet. Use the two screws to attach the flange
on each side of the front of the drive tray to the mounting rails.
78039-04
1
4
3
78039-01
Installation manual
DSA E-Series (E2700)
Bosch Sicherheitssysteme GmbH
Hide quick links:
Advertisement
Table of Contents
