Bosch DSA E-Series (E2700) Installation Manual page 43

DSA E-Series (E2700)
9.
Bosch Sicherheitssysteme GmbH
Installing the drive trays for the E2700 controller-drive tray configurations | en
– Insert one M5 screw through the front of the cabinet, and screw it into the top
captured nut in the mounting rail.
1
1 - M5 screws
– Insert two M5 screws through the rear of the cabinet, and screw them into the
captured nuts in the rear flange in the mounting rail.
– Counting up from the bottom of the mounting rail, place the bottom of the rear
bracket in the 8th hole of the cabinet, so that the top of the rear bracket is in the
11th hole. The distance between the two holes should be 1U or 4.45 cm (1.75 in).
– Tighten the adjustment screws on the mounting rail.
– Repeat the substeps to install the second mounting rail.
UP
92042-03
1 - Top cabinet mounting hole on the rear EIA support rail
2 - Bottom cabinet mounting hole on the rear EIA support rail
Remove the bezel from the front of the drive tray.
WARNING (W09) Risk of bodily injury – Three persons are required to safely lift the
component.
1
1
2
Installation manual
92011-05
2015.10 | V2 | DOC
43