E2700 Configuration Cables And Connectors - Bosch DSA E-Series (E2700) Installation Manual

14 en | Preparing for an E2700 controller-drive tray installation
4.2.2

E2700 configuration cables and connectors

2015.10 | V2 | DOC
Cabinet
– Make sure that your cabinet meets the installation site
specifications of the E2700 storage array components.
For more information, refer to the "Storage System Site
Preparation Guide".
– Depending on the power supply limitations of your cabinet,
you might need to install more than one cabinet to
accommodate the different components of the E2700
storage array.
For instructions on installing the cabinet , refer to the
installation guide for your cabinet for instructions on
installing the cabinet.
DE1600 drive tray with end caps that are packaged separately.
This drive tray can be used with all variations of the E2700
controller-drive tray.
DE6600 drive tray (shown with the separately packaged
mounting rails attached). This drive tray can be used with all
variations of the E2700 controller-drive tray.
Mounting rails and screws
The mounting rails that are available with the drive tray are
designed for an industry-standard cabinet.
iSCSI switch (optional)
Gigabit Ethernet switch for Management (optional)
IP cameras/encoders with iSCSI capabilities
AC power cords
The controller-drive tray and the drive trays ship with power
cords for connecting to an external power source, such as a wall
plug. Your cabinet might have special power cords that you use
instead of the power cords that ship with the controller-drive tray
and the drive trays.
RJ-45 Ethernet cable
This cable is used for 10-Gb/s iSCSI connections.
Installation manual
DSA E-Series (E2700)
Item
Bosch Sicherheitssysteme GmbH