Table of Contents
Advertisement
26
en | Installing the E2700 controller-drive tray
6.3
Procedure – installing drives in the E2712 controller-drive
In some situations, the controller-drive tray might be delivered without the drives installed.
Follow the steps in this procedure to install the drives. If your controller-drive tray already has
drives installed, you can skip this step.
Notice!
Risk of equipment malfunction
To avoid exceeding the functional and environmental limits, install only drives that have been
provided or approved by the original manufacturer. Drives might be shipped but not installed.
System integrators, resellers, system administrators, or users can install the drives.
Notice!
The installation order is from top to bottom and from left to right. The installation order is
important for tray loss protection because the drives might already contain configuration
information that depends upon the correct sequence of the drives in the tray.
To install drives in the controller-drive:
1.
2.
3.
4.
2015.10 | V2 | DOC
Beginning with the first drive slot in the upper-left side of the controller-drive tray, place
the drive on the slot guides, and slide the drive all the way into the slot.
Push the drive handle to the right to lock the drive securely in place.
Note: In some models, the drive handle might have the hinge on the right.
1
1 - Drive handle
Install the second drive beneath the first drive.
Install the other drives from top to bottom and then from left to right.
Installation manual
DSA E-Series (E2700)
97006-01
Bosch Sicherheitssysteme GmbH
Hide quick links:
Advertisement
Table of Contents
