Table of Contents
Advertisement
DSA E-Series (E2700)
8.
9.
8.3
Procedure – installing drives in the DE1600 drive trays
In some situations it might be required to install drives in the DE1600 drive trays.
Follow the steps in this procedure to install the drives.
Notice!
Risk of equipment malfunction
To avoid exceeding the functional and environmental limits, install only drives that have been
provided or approved by the original manufacturer. Drives might be shipped but not installed.
System integrators, resellers, system administrators, or users can install the drives.
Notice!
The installation order is from top to bottom and from left to right. The installation order is
important for tray loss protection because the drives might already contain configuration
information that depends upon the correct sequence of the drives in the tray.
Bosch Sicherheitssysteme GmbH
Installing the drive trays for the E2700 controller-drive tray configurations | en
–
Insert one M5 screw through the bottom hole of a flange on the drive tray so that the
screw goes through the cabinet rail and engages the bottom captured nut in the
mounting rail. Tighten the screw.
–
Repeat the substep for the second flange.
2
1
1 - Screw
2 - Mounting Hole
Note: The rear of the controller-drive tray contains two controllers. The top of the
controller-drive tray is the side with the labels.
Secure the side of the drive tray to the mounting rails by performing these substeps:
–
Insert one M4 screw through the side sheet metal of the drive tray into the captured
nut on the side of the mounting rail. Tighten the screw.
–
Repeat the substep for the other side.
Attach the plastic end caps onto the front of the drive tray.
–
Put the top of the end cap on the hinge tab that is part of the drive tray mounting
flange.
–
Gently press on the bottom of the end cap until it snaps into place over the retainer
on the bottom of the drive tray mounting flange.
1
Installation manual
98009-00
2
2015.10 | V2 | DOC
37
Hide quick links:
Advertisement
Table of Contents
