Table of Contents
Advertisement
44
en | Installing the drive trays for the E2700 controller-drive tray configurations
10. With the help of at least two other persons, slide the rear of the drive tray onto the
11. After the controller-drive tray is correctly aligned, remove the enclosure lift handles as
12. Secure the front of the drive tray to the cabinet. Use the four screws to attach the flange
13. Secure the side of the drive tray to the mounting rails.
2015.10 | V2 | DOC
mounting rails. The drive tray is correctly aligned when the mounting holes on the front
flanges of the drive tray align with the mounting holes on the front of the mounting rails.
WARNING (W15) Risk of bodily injury – An empty tray weighs approximately 56.7 kg
(125 lb). Three persons are required to safely move an empty tray. If the tray is populated
with components, a mechanized lift is required to safely move the tray.
shown in the following figure:
–
Use your thumb to unlatch and remove the rear enclosure lift handles (two to a
side).
–
Use the front enclosure lift handles to slide the drive tray all the way into the
cabinet.
–
After the drive tray is secure in the cabinet, use your thumb to unlatch and remove
the front enclosure lift handles (two to a side).
1
1
2
1 - Pull the thumb latch away from the drive tray to detach the hook.
2 - Shift the handle down to release the other four hooks.
3 - Move the handle away from the drive tray.
on each side of the front of the drive tray to the mounting rails.
–
Insert two M5 screws through the bottom holes of a flange on the drive tray so that
the screws go through the EIA support rail and engage the bottom captured nuts in
the mounting rail. Tighten the screws.
You had attached the second and fourth threaded holes in step 8c.
–
Repeat the sub-step a for the second flange.
–
Tighten the thumbscrew on the rear mounting bracket that you installed in step 8e to
secure the drive tray to the mounting rails.
–
Repeat the sub-step for the other side.
Note: Make sure that each drive drawer in the drive tray is securely fastened to
ensure proper air flow to the drives.
92015-01
3
Installation manual
DSA E-Series (E2700)
Bosch Sicherheitssysteme GmbH
Hide quick links:
Advertisement
Table of Contents
