Table of Contents
Advertisement
DSA E-Series (E2700)
8
Installing the drive trays for the E2700 controller-drive
tray configurations
8.1
Things to know – general installation of drive trays with the
E2700 controller-drive tray
Notice!
If you are installing the drive tray in a cabinet with other trays, make sure that the combined
power requirements of the drive tray and the other trays do not exceed the power capacity of
your cabinet.
Notice!
For important considerations about cabinet installation, refer to the "Storage System Site
Preparation Guide".
Warning!
Risk of bodily injury
!
An empty tray weighs approximately 56.7 kg (125 lb). Three persons are required to safely
move an empty tray. If the tray is populated with components, a mechanized lift is required to
safely move the tray.
If you are performing a hot add of a tray to an existing storage array, observe the following:
–
–
–
-
8.2
Procedure – installing the DE1600 drive trays
Warning!
Risk of bodily injury
!
Two persons are required to safely lift the component.
Warning!
Risk of bodily injury
If the bottom half of the cabinet is empty, do not install components in the top half of the
!
cabinet. If the top half of the cabinet is too heavy for the bottom half, the cabinet might fall
and cause bodily injury. Always install a component in the lowest available position in the
cabinet.
Bosch Sicherheitssysteme GmbH
Installing the drive trays for the E2700 controller-drive tray configurations | en
Special site preparation is not required for any of these drive trays beyond what is
normally found in a computer lab environment.
The power supplies meet standard voltage requirements for both domestic and
worldwide operation.
Keep as much weight as possible in the bottom half of the cabinet.
Installation manual
33
2015.10 | V2 | DOC
Hide quick links:
Advertisement
Table of Contents
