Honeywell GSMVLP4G Installation And Programming Manual page 9

NOTE: The default programming values are listed in the prompts below.
PROMPTS
1
Strt Prog Mode?
(Y/N)_
2
Enter Password
3
Program Device?
(Y/N)_
4
Create Password?
(Y/N)_
5
Change Password?
(Y/N)_
6
Enter Password
7
Verify Password
Table 2 – Programming the GSMVLP4G Module
ENTRY OPTIONS
[Y], [N]
[0-9, A-F, N,
S, T, X, Y]
[Y], [N]
[Y], [N]
[Y], [N]
[0-9, A-F, N,
S, T, X, Y]
[0-9, A-F, N,
S, T, X, Y]
– 9 –
DESCRIPTION
Enters programming mode.
If a password has been previously assigned,
this prompt appears.
Enter a 4-digit password (0-9, A-F, N, S, T, X,
Y).
The next prompt appears.
To begin programming the module, press [Y]
and go to Prompt 9: "Device Mode."
To create a password if none has been
assigned, press [N] and go to Prompt 4:
"Create Password?."
To change an existing password, press [N]
and go to Prompt 5: "Change Password?."
Passwords can be used to protect account and
programming information.
If no password has been assigned, this prompt
appears after pressing [N] at the "Program
Device?" prompt.
If a password is desired, press [Y] and go to
Prompt 6: "Enter Password."
If a password has already been assigned, this
prompt appears after pressing [N] at the
"Program Device?" prompt.
Press [Y] if you want to change the password.
NOTE: To clear an existing password, without
entering a new one, answer [Y] to the
"Change Password?" prompt, then press the
[Enter] key when prompted for the new
password and its confirmation.
This prompt is displayed if [Y] was pressed in
Prompt 4 or 5.
Enter a 4-digit password
(0-9, A-F, N, S, T, X, Y).
Re-enter the password as confirmation.
If the password doesn't match the first entry,
the following is displayed followed by the "Exit
Prog. Mode?" prompt:
Verify Not OK
PSWD not created
Otherwise, the "Exit Prog. Mode?" prompt is
displayed directly.