Honeywell GSMVLP4G Installation And Programming Manual page 5

2. Release the control's front case assembly from the rear case by depressing the two locking tabs at
the top of the unit with the blade of a medium size screwdriver (refer to Figure 3).
3. Install the control in accordance with the appropriate Installation Instructions.
4. Install the GSMVLP4G into the control's back case and secure it with the three provided screws.
Refer to Figure 3.
Do not block the ventilation slots in the case when installing the tie wrap mount.
5. Remove the backing from the tape on the provided tie wrap mount. Install the tie wrap mount in the
lower right corner of the back case as shown on Figure 3.
6. Connect the provided ECP/power cable between the GSMVLP4G module and the PC board and
route the cable as shown in Figure 4. This cable provides DC power and ground for the module
and ECP connections.
For best radio performance, the wires, ECP/power cable, battery and shielded audio cables
must be routed as shown in Figure 4.
7. Make the wiring connections and install the control in accordance with the appropriate
Installation Instructions. Twist the ECP/power and battery cables and ensure that they are
routed through the routing tunnels and/or the strain relief clip as shown in Figure 4.
8. Secure the wiring with the provided tie wraps as shown in Figure 4 to ensure that the cables do
not interfere with the antenna.
9. Program the GSMVLP4G. Refer to the Programming the GSMVLP4G Module section.
Figure 3 – Installing the GSMVLP4G Module
– 5 –