Central Station Messages; Gsmvlp4G Downloading - Honeywell GSMVLP4G Installation And Programming Manual

Figure 9 – A Registered GSMVLP4G Status Display (A) and
an Unregistered GSMVLP4G Status Display in Normal Operating State (B)
Figure 10 – LED Sequence for a Registered GSMVLP4G Message Transmission

CENTRAL STATION MESSAGES

The following messages are sent to the Central Station by the GSMVLP4G module for the conditions
listed below.
Alarm Condition
Power On Reset
ECP Supervision
Communication Path Restore
Test
Note: The control panel sends its own general code (E353) for a trouble condition.

GSMVLP4G DOWNLOADING

General Information
The GSMVLP4G can be used to provide high-speed up/downloading to Lynx Plus/ReadyGuard Plus
Series control panels over the GPRS network via ECP
maintenance independent of central station monitoring, and modification to sites globally.
U L
Downloading may only be performed if a technician is at the site.
Table 4 – GSMVLP4G Central Station Messages
– 22 –
ECP Mode
Alarm Code
E339 C0803
E355 C0000
5555 5555 9
communication. This allows site
ECP Mode
Restore Code
R355 C0000
R350 C0951