Ip Address Settings; Using The Ip Setting Tool - JVC KY-PZ100WU Instructions Manual

IP Address Settings

Using the IP Setting Tool

Connect the camera to be configured to the
0
network via the LAN terminal.
Download the "IPSettingTool" from the URL
0
stated on the cover page.
Connect the computer for executing the
0
"IPSettingTool" to the network to establish
communication with the camera to be
configured.
1 Start up "IPSettingTool".
2 Click the [Search] button.
.
3 Select from the list the camera to be
configured.
.
4 Enter the respective network setting items
and click the [Setting] button. After a
confirmation screen appears, click [OK].
"Default Gateway" can be omitted.
0
.
26
IP Address Settings
.
If setting is successful, the search list display
0
will be updated.
If there are multiple cameras to be
0
configured, repeat steps 3 to 4 for each
camera.
Memo :
When the "Failed in the Setting." message is
0
displayed, check the setting details and review
the connecting device then try again.
5 Click the [Close] button to exit.
.
Memo :
Cameras with the same IP address as the
0
computer for configuring the IP address cannot
be detected.
Make sure that there is no duplication in the IP
0
address configured for each camera.
When a firewall has been installed, change the
0
setting to allow communication access by the
"IPSettingTool".
The "IPSettingTool" runs on Windows. For more
0
information on setting the IP address in an
environment other than Windows, please refer
to the "Instruction Manual".