Download  Print this page

Connecting The Cables - JVC KY-PZ100WU Instructions Manual

Hd ptz remote camera
Hide thumbs

Advertisement

Connecting the Cables

1 Connect the power cable.
To supply power from an AC adapter,
0
connect an AC adapter cable.
To supply power via PoE+, proceed to the
0
next step without connecting an AC adapter
cable.
Fix the AC adapter cable with a cable clamp.
0
.
2 Connect the LAN cable.
3 Connect the SDI cable. (Optional)
4 Connect the HDMI cable. (Optional)
5 Connect the microphone cable or audio
cable. (Optional)
6 Remove the protective sheet attached to
the infrared remote control sensor.
Caution :
For safety reasons, turn on the power only after
0
ensuring that all the connections are in place.
Do not supply power through the AC adapter
0
cable and LAN cable at the same time.
Warning
To supply power to this unit, use a DC 12 V or
PoE+ (IEEE802.3at Type2) power. Make use of
the correct voltage.
Supplying a power beyond the rated value may
result in failures, smoke or fire. If the camera
breaks down, turn off the power and contact our
service center immediately.
When a power beyond the rated value is
supplied, the internal components may be
damaged even if no abnormality is found on the
appearance and operation of the camera.
Please contact our service center immediately
for servicing (charged separately).
Connecting the Cables
25

Advertisement

Table of Contents
loading

  Also See for JVC KY-PZ100WU

This manual is also suitable for:

Ky-pz100weKy-pz100buKy-pz100be