Table of Contents
Advertisement
Installing the Camera on a
Desktop
Place the camera on a flat surface.
0
Be sure to place the base of the camera
0
horizontally. The camera will not operate
properly if it is slanted.
Memo :
The use of ceiling mount bracket is not required.
0
Caution :
Do not move the camera while the power of the
0
system is on. Doing so may result in
malfunctions or accidents.
Do not hold the camera head while carrying the
0
camera.
Connect the cables after these procedures.
Attaching the Camera to a
Tripod
Attach a tripod using the screw hole at the
0
bottom of this product.
(1/4-20UNC, ISO1222 (6.35 mm))
To prevent the camera from falling off, which
0
may result in injuries or damages, read the
"INSTRUCTIONS" of the tripod to be used and
make sure that it is securely attached.
To ensure proper pan/tilt operation, set the
0
tripod such that the camera is parallel to the
horizontal surface.
Memo :
The use of ceiling mount bracket is not required.
0
Caution :
If the camera exceeds the weight limit of the
0
tripod, do not mount it on the tripod.
Use the tripod on a stable surface.
0
Use screws with a screw length between 4.5 mm
0
and 7 mm.
Do not install the camera at a high location when
0
the camera is attached to a tripod.
Connect the cables after these procedures.
Connecting the Cables
1 Connect the cables
Connecting to an HDMI/SDI monitor allows
0
you to check the camera images.
To input the audio, connect the audio cable
0
to the LINE IN terminal.
2 Connect the LAN cable.
You can operate the camera from a web
0
browser by connecting a LAN cable.
3 Connect the power cable.
To supply power from an AC adapter,
0
connect an AC adapter cable.
To supply power via PoE+, do not connect
0
the AC adapter cable.
4 After turning on the power switch, the
POWER lamp lights up and initialization
starts
The camera lens moves to both the horizontal
and vertical limit positions. Initialization is
complete after it has moved back to the front
view position.
Memo :
Operation is possible when the light of the
0
STANDBY lamp has turned off.
If Preset 1 is preconfigured, the camera will
0
move to the Preset 1 position.
Caution :
Do not supply power through the AC adapter
0
cable and LAN cable at the same time.
Warning
To supply power to this unit, use a DC 12 V or
PoE+ (IEEE802.3at) power. Make use of the
correct voltage.
Supplying a power beyond the rated value may
result in failures, smoke or fire. If the camera
breaks down, turn off the power and contact our
service center immediately.
When a power beyond the rated value is
supplied, the internal components may be
damaged even if no abnormality is found on the
appearance and operation of the camera.
Please contact our service center immediately
for servicing (charged separately).
Installing the Camera on a Desktop
23
Advertisement
Table of Contents
