Unloading The Filament; Leveling The Build Plate - Flashforge FINDER Start Up And Instruction Manual

————————————————————————————————————————————

Unloading the filament

1. Tap [Tools]--[Filament]--[Unload]. After the extruder reaches 220℃, the printer will sound a
beep to prompt you to unload the filament from the extruder. Keep pressing the spring presser
down, push filament in a little first until you see melted plastic coming out from nozzle end, then
gently pull the filament out.
Note: Do not pull out the filament with force as it will damage the gears. If the melted filament
has cooled down in the extruder, please repeat the steps above.

Leveling the Build Plate

1. Tap [Tools] - [Level] on your Finder touch screen. Please wait while the extruder and platform
finish initial movements. Screw three nuts under the platform anticlockwise until you can't
tighten them any more, then tap [OK] button. On the next pop-up dialog, tap [Yes] if you can't
finger tighten all the nuts any more, or tap [No] to continue tightening.
2. After tapping [Yes] button, the extruder starts to move towards the first point and the plate
moves up and down to verify the distance between nozzle and plate. If distance too big, please
5