Flashforge FINDER Start Up And Instruction Manual page 4

Hide thumbs Also See for FINDER:
Table of Contents

Advertisement

————————————————————————————————————————————
with buckles. Use scissors to cut them off to release the X guide rods. Discard the blue tape that
holds the flat cable in place.
5. Taking the protective foam for filament out of the Finder, you will see a spool of PLA filament
inside. Filament color is randomly selected.
6. Then you will see the build plate. The build plate pasted with a blue build plate tape is ready
for direct use. In the grooves at both sides, you will see a filament guide tube, a power cable and
a USB cable. Move the build plate up. Remove the protective foam and take the power cable and
USB cable out.
You have now unpacked your Finder successfully.
3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FINDER and is the answer not in the manual?

Table of Contents