Hardware Assembly; Place Spool Into Cartridge; Filament Loading And Unloading; Loading Filament - Flashforge FINDER Start Up And Instruction Manual

————————————————————————————————————————————

Hardware Assembly

Your Finder has been almost assembled before leaving factory; you can start up the Finder for
printing after mounting the filament spool and completing leveling.

Place Spool into Cartridge

Remove the filament cartridge in the rear of Finder, where you place the filament spool. Thread
the filament through the filament guide tube. Note: You should ensure the filament spool rolls
anticlockwise.

Filament Loading and Unloading

Connecting Power Cable
Insert the power supply into the power input on the back of the Finder and plug the power cord
into an electrical outlet.

Loading Filament

Turn on your Finder by clicking power button at the right side of the touch screen.
Then tap [Tools]--[Filament]--[Load]. Extruder is heating up. After the extruder reaches 220℃,
the printer will sound a beep to prompt you to load the filament into the extruder. Press the
spring presser down and insert the filament into the extruder at an upright angle. Within a few
seconds, you should see an even string of plastic coming out from the extruder nozzle.
Note: Your Finder will sound a warning when the filament is running out; you should feed your
Finder in time.
4