Table of Contents
Advertisement
User's Manual
Message
MANUAL TIMEOUT
MEMORY OVER FLOW
MEMORY SHORTAGE
MOTOR FAILURE n
NO PROCESS UNIT
OVERRUN ERROR
PAPER JAM n
STACKER FULL
SYSTEM ERROR n
Causes and solutions
Cause: Paper was not inserted into the
manual feeder in the prescribed time.
(This error occurs when the FPS emulation
is active.)
Solution: Press the
CONT.
Note: FPS emulation is standard for
12MX but optional for 12M.
Cause: Memory overflow error
Solution: Press the
CONT.
Cause: Insufficient memory
Solution: Add RAM boards.
Cause: Malfunction in the feed motor, etc.
Solution: If the error recurs, consult your
dealer for service.
Cause: No print unit is installed.
Solution: Install the print unit.
Cause: Incomplete in extracting
compressed data
Solution: Press the
CONT.
Cause: Paper jam in the specified position
Solution: Clear the jammed paper from
the following area:
0: From paper tray to print unit
1: under print unit or in fuser unit
2: under print unit near paper tray
3: in fuser unit
4: from eject unit to duplex unit
5: from duplex unit to print unit
6: at feed roller of 2nd paper tray
Duplex unit is optional for 12MX.
Cause: Face-down paper stacker full
Solution: Remove paper from the face-
down paper stacker.
Cause: A system error on the controller
board
Solution: If the error recurs, consult your
dealer for service.
Error Indications
button.
SOLVING
PROBLEMS
button.
button.
5-19
Advertisement
Table of Contents
