Operation Instructions; Button Control - FDS FD171CV-C-4 Installation And Operation Manual

Operation Instructions

The FD171CV-C-4 is continuously on but can be de-energized by removing power from the video
system. No pilot or aircrew action is necessary during flight or ground operation.
The operator can change the video from the FD171CV-C-4 using the Source button on the top of the
display (SDI, Analog, S-Video & Composite). When the SDI source is selected, the buttons on the
front of the display will control the quad inputs to be displayed.
When applying 28VDC power, the display will turn on and look for a valid input on the last known
source. If no input is found, the display will go to standby mode. Pressing the Source button will select
new video input.
J2 HDSDI OUT will output the current HDSDI video displayed on the monitor.
Button Controls
Located on the top of the FD171CV-C-4 are 8 buttons for display control.
BUTTON
PWR
MENU
AUTO
SCE
© 2017 FDS Avionics Corp.
All Rights Reserved.
Document Number:
MAN – FD171CV-C-4
DESCRIPTION
Turns ON/OFF the system.
Activates the OSD menu or goes to previous menu.
Auto-adjustment in RGB.
Moves the highlight icon up to the function that user
wants.
Moves the highlight icon down to the function that user
wants.
Decreases the adjustment of the selected function.
Increases the adjustment of the selected function.
(Source) Selects the Input Signal among Analog RGB/S-
Video/Composite/HDSDI.
Revision Date:
Rev:
01/11/2017
B
Page 10 of 14
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com