Mix Running
Press Play on the DAW to move forward and as soon as the Mix system has locked to the MIDI timecode (MTC),
the Mix Status display will indicate 'Mix Running'. Simply move the faders and press the cut switches to write
your mix automation, and the fader moves and cut data will be recorded. The DAW may be toggled freely between
Stop and Play and if Fast Forward is used or the DAW is located forward, the automation data will be extended
to the new position and returned to play.
24 Channel
Faders
Press End to
save the current
Mix Pass and
return to the
List Mix menu.
Revise returns faders and
cuts that were in write when
you rolled back to write at
the current mix level.
At any time you can rewind the system, and as soon as the DAW is located to an earlier time and valid MTC or
a MMC locate position command is received, the mix system enters 'Mix Review'. All faders will switch to
Replay status (all LEDs are off). This operation is known as a rollback.
00:02:12:23 Mix Review - 23
End
Revise
Misc
TR
Auto
Trim
Moff
TLock
When the DAW returns to Play, previously written automation data is replayed. If no faders are returned to write,
all faders in write at the start of the mix will drop back into write at the point where the DAW was rewound (the
'rollback point', and the Mix status will return to Mix Running. Whilst in Mix Review you may rollback as many
00:02:12:23 Mix Running
End
Revise
Misc
TR
Auto
Trim
Moff
TLock
A
Join
Lnks
DAW
Snap
AT
Match
Play
A
Join
Lnks
Snap
AT
Match
Indicates how many times you have rolled
back. Every time the Mix Review number will
increase by 1.
Mix Running Status - displayed while
writing new automation data
Mix Review Status - displayed when
Discard
rolled back and playing previous
automation data.
SSL
CS
AWS 900+ SE Owner's Manual
Stereo Bus Master
Faders
Discard
Press Discard to
SSL
DAW
abort the current
Mix Pass
Play
CS
Join returns faders and cuts
that were in write when you
rolled back to write at their
levels at the rollback point.
AWSomation
7-5
Need help?
Do you have a question about the AWS 900+ SE and is the answer not in the manual?