Typical Minimum Trigger Interval Of Sequence Roi Trigger - IAI SP-20000C-USB User Manual

"TL Params Locked = 1"
"Acquisition Start"
Next
Sequence
Index
Command
Frame Start
Trigger In
Sequence
Index 0
operation
Next Index = Index 0
7.8.5

Typical minimum trigger interval of Sequence ROI Trigger

Table - 44 Typical Minimum trigger interval (Pixel Format: 8-bit)
Trigger Mode Readout Mode
Full
ROI Center 2/3
Sequential Timed ROI Center 1/2
Exposure Mode
ROI Center 1/4
(Note 1)
ROI Center 1/8
V Binning ON
(Full) (Note 2)
Note 1. Overlap mode=Readout is not available. Please do not set the exposure time to
Readout mode.
Note 2. SP-20000M-USB only
Note 3. The minimum interval calculation assumes that the exposure time for all sequences are
equal. If there are differences, it is necessary to add the difference to the calculation.
If the exposure times are different, it is recommended to organize the exposure times
from the shortest exposure to the longest one in order to operate faster.
Note 4. The above interval is if the exposure time is set to 10 µs.
SP-20000M-USB / SP-20000C-USB
+
Set"Index 9"
After Acquisition Start, the index
is not changed
Sequence Index Command.
So, Index 0 is executed.
Fig. 34 Behavior of Command Sequence
8-bit
≧62.53 ms
≧42.02 ms
≧31.75 ms
≧16.35 ms
≧ 8.66 ms
≧62.55 ms
Index 9 Index 9
Next Index =Index 9
After Acquisition Start, the index is not
by Next changed
Command. So, the previous index is
executed again.
Time (Min. Trigger Period)
10-bit/12-bit
≧125.03 ms
≧ 55.50 ms
≧ 31.76 ms
≧ 16.38 ms
≧ 8.70 ms
≧ 62.55 ms
- 74 -
Set"Index 5"
Index 5
Next Index = Index 5
by Next Sequence Index
10bit_Packed 12bit_Packed
≧78.16 ms ≧93.78 ms
≧42.02 ms ≧42.02 ms
≧31.76 ms ≧31.76 ms
≧16.38 ms ≧16.38 ms
≧ 8.69 ms ≧ 8.69 ms
≧62.55 ms ≧62.55 ms