Converting The System From Tower Mode To Rack Mode; Safety Instructions For Converting System From Tower To Rack; Preparing A System For Conversion From Tower Mode To Rack Mode - Dell poweredge T430 Owner's Manual

Converting the system from tower mode
to rack mode
Your system can be converted from the tower mode to the rack mode.
To convert your system from the tower mode to the rack mode, you require the tower to rack
conversion kit, which contains the following items:
• Rack ears (left and right) with three screws each
• VGA module included with the control panel for rack mode
• A pair of rails (optional)
Safety instructions for converting system from tower to
rack
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: Do not attempt to convert your system into a rack unless authorized by Dell. Only
customers certified by Dell for tower to rack conversion can convert a tower system into a rack
system.
NOTE: For specific caution statements and procedures, see the rack installation documentation for
your system at Dell.com/poweredgemanuals. For complete safety and regulatory information, see
the safety instructions that shipped with your system.
Observe the following precautions for stability and safety of the system in rack mode:
• Before installing your equipment in a rack, install the front and side rack stabilizers. Failure to install
the stabilizers can cause the rack to tip over.
• Always load from bottom up, and load the heaviest items first.
• Do not overload the AC power supply branch circuit that provides power to the rack.
Preparing a system for conversion from tower mode to
rack mode
Prerequisites
1. Ensure that you follow the safety instructions for converting system from tower to rack.
2. Keep the Phillips #2 screwdriver ready.
32
2