Internal Dual Sd Module (Optional); Removing The Internal Dual Sd Module - Dell poweredge T430 Owner's Manual

Figure 73. Installing the SD vFlash card
1. SD vFlash card
Related links
Safety instructions

Internal dual SD module (optional)

The Internal Dual SD Module (IDSDM) card provides two SD card slots. This card offers the following
features:
• Dual card operation — maintains a mirrored configuration by using SD cards in both the slots and
provides redundancy.
NOTE: When the Redundancy option is set to Mirror Mode in the Integrated Devices screen of
System Setup, the information is replicated from one SD card to another.
• Single card operation — single card operation is supported, but without redundancy.

Removing the internal dual SD module

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the cooling shroud.
4. Locate the Internal Dual SD Module (IDSDM) on the system board.
5. If installed, remove the SD card(s).
Steps
Hold the pull tab and pull the IDSDM out of the system.
2. SD vFlash card slot
161