Table of Contents
Advertisement
Next steps
1.
Install the main power interposer
Installing the main power interposer board
Prerequisites
Follow the safety guidelines listed in
Steps
1. Align the screw holes on the main power interposer board (PIB) with the holes on the system chassis.
2. Using the Phillips #2 screwdriver, secure the main PIB to the system using the screws.
3. Connect all the disconnected power cables to the main PIB.
Figure 119. Installing the main power interposer board
Next steps
1. If removed,
install the GPU
2.
Install the system
board.
3.
Install the power supply
4. Follow the procedure listed in
Converting the system from tower mode to rack mode
Your system can be converted from the tower mode to the rack mode.
To convert your system from the tower mode to the rack mode, you require the tower to rack conversion kit, which contains
the following:
● Rack ears (left and right) with three screws each
● VGA module
● VGA cable
● Rack slide cover
● Mylar cover
Converting the system from tower mode to rack mode
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
160
Installing and removing system components
board.
Safety instructions
PIB.
units.
After working inside your system
Safety instructions
Before working inside your system
on page 66.
on page 67.
on page 66.
on page 67.
Advertisement
Table of Contents
