Restarting And Resetting The Controller - HP MSM765 zl Installation Manual

10. Disconnect your computer from the controller LAN port. Connect it to the same network to
which the controller Internet port is connected. Configure the Ethernet port on your computer
with an IP address (or addressing method) that is compatible with this network.
1 1. Open the controller web interface in your browser by specifying the controller Internet port IP
address.
12. On the Login page, enter the new login credentials you defined for Username and Password,
and then select Login.
13. You will be prompted to try the new Simplified UI.
Select Let's try it out to switch to the Simplified UI. The Simplified UI provides access to
the most commonly configured controller options, and features wizards to make
configuration tasks easy. For initial configuration of the controller, HP recommends using
the Simplified UI. The first time the Simplified UI starts, it shows the product tour, which
provides a quick overview of the key features of the interface.
Select Try it Later to stay in the Advanced UI, which provides access to advanced
configuration settings on the controller. (This is the same interface that was used in previous
software releases.)
14. You are now ready to connect a controlled AP and deploy a wireless network.
If you are using the Simplified UI, open the online help and select the topic Working with
controlled APs under the section Tell Me About.
If you are using the Advanced UI, see Working with controlled APs in the MSM Controllers
Configuration Guide.

Restarting and resetting the controller

Restarting the controller
HP recommends that you use the web interface to restart the controller as follows:
Simplified UI
Select Views > Home > Summary > Restart.
Advanced UI
Select Controller >> Maintenance > System > Restart.
Alternatively, the switch CLI can be used:
1. Enter the switch CLI configuration context:
config
2. Initiate a controller restart:
services <slot-id> reload
Where <slot-id> identifies the switch slot containing the controller. A confirmation message
appears. Respond with "y" to continue.
The following sample screen shows the commands from the above two-step procedure for an
controller in slot A:
18 Initially connecting and configuring