Ping/Traceroute; Table 34: Debug-Capture; Figure 46: Capture Files - Grandstream Networks GWN7000 User Manual

The below table will show different fields used on capture page
File Name Enter the name of the capture file that will be generated.
Choose an Interface (WAN port1 or 2, or a network group) from where to begin
Interface
the capture.
Device Choose a device plugged to USB port to save the capture once started.
Set a File size that the capture will not exceed (Optional field).
File Size
Rotate Count Set a value for rotating captures (Optional Field).
Choose if you want to get all traffic or only outgoing or incoming to the choses
Direction
interface.
Source Port Set the Source Port to filter capture traffic coming from the defined source port.
Set the Destination Port to filter capture traffic coming from the defined port.
Destination Port
Source IP Set the Source IP to filter capture traffic coming from the defined source IP.
Set the Destination IP to filter capture traffic coming from the defined destination
Dest IP
IP.
Choose ALL or a specific protocol to capture (IP, ARP, RARP, TCP, UDP, ICMP,
Protocol
IPv6)

Ping/Traceroute

Ping and Traceroute are useful debugging tools to verify reachability with other clients across the network
(WAN or LAN). The GWN7000 offers both Ping and Traceroute tools for IPv4 and IPv6 protocols.
To use these tools, go to GWN7000 WebGUI->System Settings->Debug and click on Ping/Traceroute.

Figure 46: Capture Files

Table 34: Debug-Capture

GWN7000 User Manual
P a g e | 81