Three options are available:
Multi-WAN
Disabled
This will disable Multi-WAN feature
If chosen failover will be enabled on WAN ports, admins need to choose the
Failover
Primary WAN port to be used.
When selected, user can set Multi-WAN parameters on WAN ports.
In addition to failover, load balance will be used on both ports to optimize the
Load Balance +
resource utilization. Please note that for this feature to work, WAN ports should be
Failover
connected to different networks.
When selected, user can set Multi-WAN parameters on WAN ports.
Shows the list of banned clients MAC addresses, other MAC addresses could be
Banned Client MAC
also added by clicking on
MAC Override feature is used to give a virtual MAC address to the GWN7000, in
order that any client connected to the Router will be using the entered MAC
MAC Override
address.
Note: Please make sure to enter the Override MAC address in lower cases.
Port Mirroring
With port mirroring enabled, the GWN7000 will send a copy of all network packets seen on one LAN port
to another port, where the packet can be analyzed. Refer to the below table for the available fields to
configure.
Enable Outgoing
Check to enable outgoing mirroring for a LAN port. Default is "Disabled"
Mirroring
Enable Incoming
Check to enable incoming mirroring for a LAN port. Default is "Disabled"
Mirroring
Select which LAN port that will be mirroring traffic. Default is "Disabled"
Mirroring Port
Select which LAN port that will act as mirrored port. Default is "Disabled"
Mirrored Port
Static Routes
GWN7000 supports setting manually static IPv4 and IPv6 routes as well as displaying routing table entries.
Static routes configuration page can be accessed from GWN7000 WebGUI->Router->Static Routes:
Table 9: GWN7000 WEB GUI->Router->Port->Global Settings
•
Disabled
•
Failover
•
Load Balance + Failover
Table 10: Port Mirroring
GWN7000 User Manual
or removed by clicking on
.
P a g e
|
26