Steering Assembly - Taylor-Dunn SS5-34 Operation, Troubleshooting Manual

SS5-36, SS5-46 and MX-600 Steering Assembly
In order to disassemble this steering gear box, follow this procedure. Refer to the
illustration on the previous page.
1. Park the vehicle on a level surface and block all the wheels.
2. Remove the cap from the center of the steering wheel.
3. Remove the nut from the center of the steering wheel.
4. Remove the steering wheel from the shaft.
5. Remove the 6 bolts from the top cover.
6. Lift the top cover off the gear box, discarding the gasket.
NOTE: The stem and gear may come out of the gear box
when removing the top cover. Do not let the gear drop to the
floor.
7. Remove as much grease as possible from the inside of the gear box
and dispose of it properly.
8. Remove the gear case and clean the remaining grease from the
bottom of the gear box.
9. If the stem and gear did not come out with the top cover, remove it
now.
10. Remove and discard the lower gasket.
11. Clean all parts, except for the gaskets in solvent.
12. Reassemble in reverse order installing new gaskets.
NOTE: Check the bronze bushings for wear and replace them
as needed.
13. Apply grease to all gears.
3-27