Delay Tie (I) - Keithley 595 Instruction Manual

IEEE-488 PROGRAMMING
4.9.13 Delay Time (I)
Purpose
Format
Parameters
Description
Default
Reference
Example
Used to program the step-to-measurement delay time for a square wave or staircase
waveform; or reading delay time for DC tid OFF waveforms.
Innn.nn
nnmnn = 000.07sec to 199.99sec
NOTE: Only as many significan-dig& as necessary need be sent (i.e. send I2 in
place of 1002.00).
The Model 595 displays readings which are calculated from input measurements.
The measurements are taken after the delay time. The step time (regardless of out-
put waveform) is the delay time +.04sec (see specification clarification at beginning
of manual). Capdance readings are displayed for every other step; -nt readings
are displayed for each step. See Figure 3-3 for an illustration of delay time.
Upon power up or .+ter a ~DCL or SDC command is received, the delay time will
be set to 0.07 seconds (I.07).
The equivalent front panel controls for the I cornman d are the DELAY TlME and
ADJUST buttons. See paragraph 3.3.10 for complete information on delay time.
Enter the following program statements into the computer to set a delay time of three
seconds:
REMOTE 728
UUTPIUT 728; i ( I!%' '
OlJTPlJT 728; r r 13x' s
After
END
LINE is pressed the second time, the presently programmed delay time
will be displayed. After END LINE is pressed the third time, the delay time will be
three seconds.
4-27