Step Voltage (S) - Keithley 595 Instruction Manual

4.9.12
Step Voltage (S)
Purpose
Foimat
Default
Reference
Example
Use to set the step voltage magnitude of a square wave or staircase.
Sn
n = 0 1OmV step
n = 1 2OmV step
n = 2
5OmV step
n = 3
1OOmV step
n = 4
-1OmV step
n = 5
-20mV step
n = 6
-50mV step
n = 7
-1OOmV step
The S command defines the magnitude and direction of each voltage step. This com-
mand applies to square wave and staircase waveforms.
Upon power up or after a DCL or SDC commandis received, the step voltage will
be 5OmV (52).
The equivalent front panel controls for the S command are the STEP V, ADJUST
and +I- buttons. See paragraph 3.3.8 for complete information on step voltage.
Enter the following statements into the computer to set the step voltage to IDOmVz
When END LINE is pressed the second time the presently programmed step voltage
will be displayed. When END LINE is pressed the third time, the step voltage will
set to 1OOmV.
4-26