Telephone Line Checking; Factory Default Reset - jablotron JA60K Installation Manual

Store number to call Pager (to memory number 5) entering:
7 xx..x F9 zzz....zz F5
As a maximum 32 digits can be stored to memory # 5. Special characters can be entered with the following Fx codes:
pause F0
∗ ∗ ∗ ∗ F7
# # # # F8
Example: enter 7 0611 F9 1 1234 555 F80 F5 if the provider prefix is 0611, the Pager number 1234 and the message 555.
Number 1 after F9 is a language selector, code F80 represents #0 #0 #0 #0 = end of message.
Note: some Paging providers also offer an option to send the message as an SMS to the GSM network. Consult your
Paging provider for details if you have trouble sending a message to the Pager.
To delete the Pager number enter:
7 F0 F5
If the memory number 5 is empty, no message will be sent to a Pager.
Factory default setting: all memories from 1 to 5 are empty.
7.2.24. Voice message recording*
Press shortly key 8 then press key 0 and hold it pressed while talking into the control panel's front grid (max. 20 seconds).
After releasing the 0 key, the message will play back. The message is stored in non-volatile memory and can be changed
when ever you want to by repeating the above steps. Make the message clear and brief. The dialer repeats the message
to each called number for 40 seconds.
7.2.25. Telephone dialer testing*
Enter 89 and the dialer will call the programmed numbers once. You will hear the telephone line signals from the built in
speaker during the test (if the dialer is triggered with an alarm in normal operation, it will call silently). Testing can be ter-
minated with the N key.
7.2.26. Dialing method*
Enter:
9 0 1
9 0 0
Factory default: tone dialing
7.2.27. Telephone dialer triggering*
With sequences from 91x to 95x you can select which alarms will trigger the telephone dialer to call and which ones will
not. Enter:
9 y x
where
y
1
2
3
4
5
Example: if the dialer should not call when the system is tampered with, enter 940
Factory default setting: all alarms will trigger the dialer (it means 911, 921, 931, 941 & 951)
Alarm system JA-60 "COMFORT"
where = provider prefix
xx...x
F9 = separator
(it will wait for a provider's signal and will switch to DTMF if not used)
= pager number and numeric message and other specific codes (language selec-
zzz...zz
tors, end of message etc.) if requested by the Paging provider
F5 = to store the number to memory no. 5
for tone dialing
for pulse dialing (this option is blocked for some countries)
alarm
Panic – silent
Intruder
Fire
Tampering
Technical trouble
x reaction
not to call
0
1 to call
-
16 -
sequence: 8 0
sequence: 8 9
sequence: 9 0 x
sequences: 9 y x
MDY51306