Single Partition System; Multiple Partition System - Honeywell VISTA-128BPT Programming Manual

VISTA-128BPT/128BPT-SIA/250BPT PROGRAMMING GUIDE
Item
-
-
-
-
User Authority Level 6
* Programming at installation may be subordinate to other UL requirements for the intended application.
** Combined Entry Delay and Abort Window should not exceed 1 minute.
NOTES:
• Using the Call Waiting Cancel feature on a non-Call Waiting line will prevent successful communication to the central
station.
• The control unit must be installed with a local sounding device and an off-premise transmission for Contact ID
communication format.
• Refer to the User Guide for procedures on Testing the System.
• During Test mode, no alarm reports are sent to the central monitoring station.
NOTE: All references to the VISTA-128BPT also pertain to the VISTA-128BPTSIA. All references in this manual for
number of zones, number of user codes, number of access cards, and the event log capacity, use the VISTA-
250BPT's features. The following table lists the differences between the VISTA-128BPT/VISTA-128BPTSIA
and the VISTA-250BPT control panels. All other features are identical.
Number of Zones
Number of User Codes
Number of Access Cards
Event Log Capacity
VistaKey Modules
The purpose of this document is to provide a quick and easy way to program your entire system. A recommended
programming procedure is included, followed by a list of program fields with the corresponding program group they
belong to (system-wide, partition-specific, scheduling, etc.). Two program forms are included. One contains all the
programming fields, and the other contains the partition-specific fields. If you are setting up a single-partition system,
the partition-specific fields become system-wide fields.
Following the program forms are system layout worksheets. We recommend that you use these sheets to plan your
system before programming is performed. If you need further information about specific programming options, see the
VISTA-128BPT/VISTA-250BPT Installation and Setup Guide.
Make sure that one two-line alpha keypad is connected to the control and is set to device address "00."
S S i i n n g g l l e e - - P P a a r r t t i i t t i i o o n n S S y y s s t t
The system default is for a single-partition system. Use the VISTA-128BPT/VISTA-250BPT SINGLE PARTITION
PROGRAMMING FORM when programming for single-partition usage.
RECOMMENDED PROGRAMMING PROCEDURE of this document for proper programming procedure.
M u l t i p l e - P a r t i t i o n S y
M u l t i p l e - P a r t i t i o n S y
You must enter the number of partitions you are using in data field 2∗00 to set the system for multiple partitions. Use
the VISTA-128BPT/VISTA-250BPT SINGLE PARTITION and the PARTITION-SPECIFIC PROGRAM FORMS when
programming the system for multiple partitions. Follow the steps outlined in RECOMMENDED PROGRAMMING
PROCEDURE of this document for proper programming procedure.
Feature
Exit Time and Progress
Annunciation/Disable for
Remote Arm (Not Evaluated for
SIA CP-01)
Programmable Cross Zoning
Time
Cancel Window
Cancel Annunciation - Keypad
displays "Alarm Cancel" when
report is received
Duress Feature
Feature
e e m m
s t e m
s t e m
Range
Always Enabled
Both zones must be
faulted within 5 minutes
5 minutes
NA
NA
VISTA-128BPT/VISTA-
128BPTSIA
128
150
250
512
8
2
Shipping SIA
Default Requirement*
Enabled Enabled
Per Per walk path in
Manufacturer protected
premises
Enabled Not required to
be
programmable
Enabled Enabled
Disabled Disabled
VISTA-250BPT
250
250
500
1000
15
Follow the steps outlined in