Honeywell VISTA-128BPT Programming Manual page 52

VISTA-128BPT/128BPT-SIA/250BPT PROGRAMMING GUIDE
PROMPT
010 INPUT S/N: L
A XXX-XXXX -
010 INPUT S/N: L
A022-4064 1
010 INPUT S/N: L
A000-0000 1
XMIT TO CONFIRM
PRESS ∗TO SKIP
Entd A022-4063 1
Rcvd A022-4064
Zn ZT P RC In L
011 00 1 10 00 1
After you have enrolled each wireless device, remove ONE of the serial number labels from that device and affix it in
the appropriate column on the worksheets provided later in this Programming Guide; then enter the other
information (zone number, zone type, etc.) relevant to that device.
EXPLANATION
If you entered RM, RF, BR, UR or SL for the Input Type, this screen displays. Otherwise the summary
screen for the next zone displays.
Enter the 7-digit serial number, using one of the following methods:
a. Transmit two open and close (or close and open) sequences. For a wireless key transmitter, press
and release the button, wait approximately 4 seconds, then press and release the button a second
time.
OR
b. Manually enter the 7-digit serial number printed on a label on the transmitter, using the alpha
keypad. Then press the [∗] key, the cursor will move to the "L" position. You can edit the loop
number, if necessary. When the loop number is acceptable, press [∗].
OR
c. Press key [C] to copy the last serial number enrolled (used when programming a transmitter with
several input loops).
Remember, the [A] key to move to the right, the [B] key to move to the left and, the [#] key to back up
without saving.
Press [∗] to accept the serial number and advance to the "L" position (if method "a" or "c" was used), then
enter the loop number.
• If necessary, press the [#] key to back up without saving, and re-enter or edit the serial number
before pressing [∗] to save.
• The system checks for a duplicate. If a duplicate serial/loop number combination is found, the
keypad will emit a single long beep, and display the serial number along with a "?" for the loop
number, allowing you to re-enter the correct loop number.
To Delete an Existing Serial Number, enter "0" in the loop number field.
• The serial number will change to "0"s, pressing [∗] erases the serial number and returns an AXXX-
XXXX, indicating it's ready to enroll the new serial number.
• If "0" was entered in error, simply re-enter the loop number or press [#], and the serial number will
return to the display.
The prompt to confirm appears. This prompt only appears if you answered "Yes" at the "SET TO
CONFIRM?" prompt.
• The system enters a confirmation mode so that the operation of the actual programmed input can
be confirmed.
• Activate the loop input or button that corresponds to this zone. At any time during this step, you
may press the [∗] key on the keypad to save the serial and loop number combination without
confirming.
If the serial number transmitted does not match the serial number entered, a display similar to the
one at the left appears. If the loop number does not match, it also is displayed.
• If so, activate the loop input or button on the transmitter once again. If a match is not obtained (i.e.,
summary display for the next zone does not appear), press the [#] key twice and then enter or
transmit the correct serial number.
• Activate the button on the wireless key again after re-entering the serial number.
If the serial number transmitted matches the serial number entered, the system beeps 3 times and
advances to the summary display for the next zone's programming.
After all the zones have been programmed, enter 000 for the zone number to quit.
48