Entering And Exiting Programming Mode - Honeywell VISTA-128BPT Programming Manual
Burglary partitioned security system
Hide thumbs
Also See for VISTA-128BPT:
- Installation and setup manual (124 pages) ,
- User manual (88 pages) ,
- Overview (13 pages)
Table of Contents
Advertisement
VISTA-128BPT/128BPT-SIA/250BPT PROGRAMMING GUIDE
12. Define user access codes.
Refer to User Access Codes in the VISTA-
128BPT/VISTA-250BPT Installation and Setup
Guide to program authority level, O/C reporting
option, partition assignments, and RF key
assignments for each user.
13. Exit Programming Mode.
Exit programming mode by pressing either ∗98 or
∗99. Additional entries of ∗99 are required if the
exit is being done from fields 1∗00 and above.
To prevent re-access to programming mode using
the Installer's code, use ∗98. The only way to re-
access programming mode is by depressing both
the [∗] and [#] keys at the same time within 30
seconds of power-up.
Exiting by using ∗99 always allows reentry into
programming mode using the Installer code.
Either way of exiting allows access via
downloading.
E
n
t
e
r
i
n
g
a
n
d
E
x
i
t
E
n
t
e
r
i
n
g
a
n
d
E
x
i
t
Enter Programming mode using either method a or b:
a.
Press both the [∗] and [#] keys at the same time within 30 seconds after power is applied to the control.
b.
Enter the Installer Code + [8] + [0] + [0] + [0] keys. The factory installer code can be changed once in the Program
mode (field ∗00).
NOTE: The default for the Installer Code is 4140.
Exit the Programming mode by either method a or b:
a.
Press [∗] + [9] + [8]. Exiting by this method prevents the installer code from being used to re-enter Programming
mode. Only method "a" can be used to re-enter Programming mode.
b.
Press [∗] + [9] + [9]. Exiting by this method permits the installer code to be being used to re-enter Programming
mode.
i
n
g
P
r
o
g
r
a
m
m
i
n
g
i
n
g
P
r
o
g
r
a
m
m
i
n
g
NOTE: If local programming lockout is set via
M
o
d
e
M
o
d
e
4
downloading, programming mode cannot
be entered at the keypad. In the event
that local programming is required
after the lock-out, setting the location in
Compass will open a 24-hour window for
programming when the Master code +
#65-command is entered. The 24-hour
window counts down and then locks out
local programming until the next
Master code #65-command is entered.
Hide quick links:
Advertisement
Table of Contents
