Remote Operation Of The Machine - Sharp MX-M905 User Manual

BEFORE USING THE MACHINE►BEFORE USING THE MACHINE

REMOTE OPERATION OF THE MACHINE

Remotely operate the machine on your computer.
You can operate the machine from the same panel as the machine's operation panel that is displayed on your PC, with
the same feel as operating in front of the machine.
LINE PRINTER
Easy HDD
Sharp OSA
Scan File retrieve
Send and Print
No. of copies 1
Quick File
Original
7 8 9
Store Data Temporarily
Auto 8½x11
File
Paper Select
4 5 6 Store Data in Folder
Auto
Call Eco Program
2-Sided Copy
1 2 3
1-Sided→1-Sided
Copy Ratio
0 C
100%
Exposure
Auto
Plain 1
8½x11
Output
Preview
Proof Copy
N-Up
Off
1 2
8½x11 8½x11 5
3 8½x11
Others
4 11x17 8½x11
Operate the machine
using your computer
screen.
The remote operation function can only be used on one computer at a time.
Before you can use the remote operation function, the following preparation is required.
• In "Settings (administrator)", select [System Settings] → [Common Settings] → [Operation Settings] → [Condition
Settings] → [Remote Operation Settings] → [Remote Software Operation] and select [Allow] for [Operational Authority].
• Connect the machine to the network.
• Install a VNC application software (recommended VNC software: RealVNC) in your computer.
After the preparation is completed, follow the operation described below to set up the function.
Example: RealVNC
1
Check with the administrator of the machine for its IP address.
Follow the message on the operation panel of the machine to permit the
2
connection.
When the machine is connected to a VNC application software,
If you wish to disconnect, exit the VNC application software or tap
Use the operation panel in the same way as you would on the machine. However, you cannot enter values in series by
continuously clicking the key.
Job Status
Your computer
CA
Start
LINE PRINTER
Easy HDD
Sharp OSA Job Status
Scan File retrieve
Send and Print
No. of copies 1
Original Quick File
7 8 9
Store Data Temporarily
Auto 8½x11
File
Paper Select Store Data in Folder
4 5 6
Auto
Call Eco Program
2-Sided Copy
1 2 3
1-Sided→1-Sided
Copy Ratio
C
100% 0
Exposure
Auto
Plain 1
8½x11
Output Preview CA
N-Up Proof Copy
Off
1 2
8½x11 8½x11 5
3 8½x11
Others Start
4 11x17 8½x11
Operation panel
Network
Start the VNC viewer, enter the IP
address of the machine in the "VNC
Server" entry box, and click the
[Connect] button.
appears on the system bar of the machine's touch panel.
.
1-54
The machine